VGA and Audio over UTP (Cat5/5e/6) Transmitter Wallplate Order toll-free in the U.S. 800-959-6439 FREE technical su
Model UVA-WP 8 2.4 Connecting the Transmitter to the Receiver The UTP RJ45 wiring follows the standard EIA/TIA568B (shown below) NOTICE Do not con
Wallplate VGA and Audio on UTP Transmitter 9 Connect the remote monitor and speakers to the URA or another compatible receiver unit (as sho
Model UVA-WP 10 There is a potentiometer (pot) or pushbuttons on the Model URA receiver depending on the products revision. Turning the pot CW incre
Wallplate VGA and Audio on UTP Transmitter 11 3. Operation 3.1 UTP Cable Recommendations UTP cables have 4 twisted pairs inside. The UVA/URA vi
Model UVA-WP 12 This effect gets worse at high resolutions, high refresh rates, long cables (in excess of 200 feet), and depends on the cable constr
Wallplate VGA and Audio on UTP Transmitter 13 4. Troubleshooting 4.1 Problem Solving FAQ 1. Fuzzy, blurry, or ghosting image at remote location
Model UVA-WP 14 4. Poor audio quality at the receiving end Only use powered speakers with the receiver. It is also good practice to set the audio l
Wallplate VGA and Audio on UTP Transmitter 15 5. Specifications Supported Video Types VGA through UXGA, RGBS, or RGB Can also transmit Composit
© Copyright 2009. Hall Research, Inc. All rights reserved.1163 Warner Ave. Tustin, CA USA Ph: (714)641-6607, Fax (714)641-6698
Wallplate VGA and Audio on UTP Transmitter 1 TRADEMARKS USED IN THIS MANUAL Hall Research, HR, and its logo are trademarks of Hall Research, Inc.
Model UVA-WP 2 Contents 1. Introduction... 3 1.1 General...
Wallplate VGA and Audio on UTP Transmitter 3 1. Introduction 1.1 General The Model UVA-WP is a single-gang wall plate that can transmit PC VGA vi
Model UVA-WP 4 1.2 Features • Handles resolutions up to 1080p (HD YPbPr) or 1920x1440 (PC VGA) at any refresh rate • Rugged, Reliable, Compact siz
Wallplate VGA and Audio on UTP Transmitter 5 2.2 Installation into a Wall, Desk or Podium • If you will be using a PC or notebook, test the tran
Model UVA-WP 6 2.3 Connecting the Power Supply • There is a 2-position screw terminal on the back of the unit. You need to connect a 6 volt (could
Wallplate VGA and Audio on UTP Transmitter 7 • If you do not want to cut off the connector on the end of the power supply, then use the enclosed
Comentários a estes Manuais