Hall-research UVA-8 Manual do Utilizador descarregar pdf (Página 9)

4 or 8 Channel Splitter PC Video & Audio over Twisted-Pair Receivers

3.3 Advanced Brightness Adjustment on URA Receivers

The URA series of devices can equalize the brightness of the video by reducing

smearing.

• Apply power to the receiver. Wait until all LED’s are turned off

• Press the SEL button once to enter Adjustment-mode.

• In Adjustment-mode, all three (3) LEDs will be ON solid.

• Press and hold the SEL button for at least 3 seconds to enable the

Video Brightness Adjustment Mode (previously called Wire Gauge

Mode).

• In Video Brightness Adjustment Mode, the GREEN and BLUE

LED’s will be blinking.

• The UP button raises the video brightness level.

• The DOWN button lowers the video brightness level.

• Pressing BOTH the UP and DOWN buttons at the same time will

reset the Video Brightness to the default setting.

• While using the UP and DOWN buttons, if an upper or lower limit of

the adjustment is reached, the brightness will no longer change with

each button press.

• To exit the Video Brightness Adjustment mode at any time, press

the SEL button until all LED’s are ON solid (Adjustment-mode).

Press the SEL button repeatedly until all LED’s are OFF indicating the

unit is ready for operation. (The unit will automatically return to this

mode after 1 minute if no buttons are pressed).

Note

The Video Brightness adjustment may not be noticeable when only using 1 device.

When products are daisy-chained using the –XT version the adjustment is easier to

observe.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Hall-research UVA-8 Manual do Utilizador Página 9