Hall-research UHBX-3S Manual do Utilizador

User’s Manual UHBX-3S HDMI On HDBaseT™ 1x3 Splitter with Local Loop-out, RS232, & PoH Split HDMI & Extend Video, Audio, RS23

UHBX-3S 10 received at the remote site if the command was issued with the HDBaseT link in low-power mode. This byte is typically hex FF or FE and w

UHBX-3S 11 7.0 Specifications Input & Output ports Input Port 1x HDMI Female (Type A) Output Port 1x HDMI Female (Type A), 3x RJ45 c

UHBX-3S 12 © Copyright 2014. Hall Research, Inc. All rights reserved. 1163 Warner Ave., Tustin, CA

UHBX-3S 2 Table of Contents 1.0 Introduction 3 2.0 Features 4 3.0 Setup 5 3.1 Package Contents 5 3.2 Installation 5 4.0 Operation 7 4.1 Fron

UHBX-3S 3 1.0 Introduction The UHBX-3S is an HDMI 1.4 compliant splitter with one local HDMI output and 3 HDBaseT™ outputs for transmission to comp

UHBX-3S 4 additional +48V power supply must be connected to UHBX-3S. Note that the +48V power supply is not included with the UHBX-3S. UHBX-3S als

UHBX-3S 5 3.0 Setup 3.1 Package Contents All UHBX-3S units are shipped with +5V power supply, a 1m HDMI cable and a male-to-female RS-232 cable.

UHBX-3S 6 Figure 4 – Two UHBX-3S units daisy-chained together A maximum of 7 splitters can be daisy chained in this manne

UHBX-3S 7 3.2.1 Sender Serial Connections Connect the RS-232 input (Female) connector to your controller or PC using a straight-through male-to-fe

UHBX-3S 8 4.2 EDID Management One of the distinguishing features of the UHBX-3S is EDID management. It supports two modes of operation Pass-Throug

UHBX-3S 9 5.2 Serial Commands Command: XC,n <cr> stands for Serial Connect Connect serial interface to an output (n). If n is not specif